Changing the Video Input/Output Methods
A-8
A.2.3
Using Component Video Output
To switch to highest-quality component video output, follow these steps:
1) Connect your component video connectors to the connectors in a
square on the far left of the board. Instead of connecting one
connector as with composite video, connect the YPrPb connectors
as shown here.
The DVEVM kit does not include a 3-connector cable used for
component (YPrPb) video. In addition, you will need a video display
with component video inputs.
2) On the kernel command line, you can configure the DVEVM to select
both NTSC vs. PAL and the component video output format (see
Section 4.3.6,
Configuring the Boot Setup for PAL Video Users
). For
example, if you want both NTSC and component video output, use
the following:
video=dm64xxfb:output=ntsc:format=component
If you want both PAL and component video, use the following:
video=dm64xxfb:output=pal:format=component
Pr
Pb
Y
Summary of Contents for DVEVM
Page 1: ...DVEVM Getting Started Guide Literature Number SPRUE66A August 2006...
Page 14: ...1 6...
Page 70: ...Index 4...