J24
f
c
CN1,CN2
CN3,CN4
c
FPD-LINK III I/O
d
GPI/O
e
FUNCTION CONTROLS
f
POWER SUPPLY
g
MIPI CSI-2 OUTPUTS
h
I2C BUS
i
POC CONFIG
j
USB2ANY CONNECTOR
d
J2
e
S1
+12VDC
g
J6,J7
h
J4,J5
1.1V
+5%
1.8V +5%
3.3V
+10%
e
SW1
J32
i
j
J36
Quick Start Guide
9
SNLU177 – July 2016
Copyright © 2016, Texas Instruments Incorporated
DS90UB96X-Q1EVM User's Guide
1.7
Quick Start Guide
1. Connect mini USB J36 to USB port for register programming
2.
Optional :
Connect an external I
2
C host adapter I
2
C signals on J4 port for register programming
3. Configure switches S1 and SW1 to set device’s operating modes
4. Configure VFEED power supply for each channel of CN1, CN2, CN3, CN4 on J32 header
5. Plug the four sensors into the four DS90UB913A serializer boards to create four camera modules
6. Connect the four camera modules to channels 1, 2, 3, and 4 using coax cables on CN1, CN2, CN3,
CN4
7. Interface MIPI CSI-2 output signals (J6 or J7) to application processor
8. Provide power to board on J24 (+12VDC)
(a) Op1.1VDC power supply on J22
(b) Op1.8VDC power supply on J28
(c) Op3.3VDC power supply on J29
9. For details of pin-names and pin-functions, please refer to the DS90UB96X-Q1 datasheet.
Figure 1-3. Interfacing to the EVM
1.8
Demo Board Connections
1.8.1 Power Supply
Table 1-2. Power Supply
Reference
Signal
Description
J20.1
+12V
Main Power
12VDC (nominal) power connector that supplies power to the
entire board.
J22.1 (Optional)
+1.1V
1.1V ±5%
Alternative to Main Power