Texas Instruments DS90UB96X-Q1EVM, User Manual, Page: 15 / 65

www.ti.com
Enable and Reset
15 SNLU177 – July 2016
Submit Documentation Feedback
Copyright © 2016, Texas Instruments Incorporated
DS90UB96X-Q1EVM User's Guide
Table 1-14. CMLOUTP Output Signals
Reference Signal Description
TP1 CMLOUTP Test Pad for Channel Monitor Loop-through Driver
TP2 CMLOUTN Test Pad for Channel Monitor Loop-through Driver
(1)
Only set one ON.
(2)
This function is only available with 2-MP ADAS chipsets.
Table 1-15. Mode SW-DIP4 - S1
(1)
Reference Mode Description
S1.1 1 CSI Mode (2-MP ADAS Tx compatible)
(2)
S1.2 2 RAW12 / LF (DS90UB913A compatible)
S1.3 3 RAW12 / HF (DS90UB913A compatible)
S1.4 4 RAW10 (DS90UB913A compatible) (Default)
Table 1-16. Control SW-DIP2 - SW1
Reference Signal Input = L Input = H Description
SW1.1 TESTEN
For Normal operation
(Default)
Test Mode enable Test Mode
SW1.2 PDB Device is powered down Device is enabled (Default) Power-down Mode
Table 1-17. LEDs
Reference LED Name Description
D2 GPIO0 Illuminates if GPIO0 is ON
D3 GPIO1 Illuminates if GPIO1 is ON
D4 GPIO2 Illuminates if GPIO2 is ON
D5 GPIO3 Illuminates if GPIO3 is ON
D6 GPIO4 Illuminates if GPIO48 is ON
D7 GPIO5 Illuminates if GPIO5 is ON
D8 GPIO6 Illuminates if GPIO6 is ON
D9 GPIO7 Illuminates if GPIO7 is ON
D11 VDD_EXT Illuminates if 12V Power is applied to DC-IN J24
D12 VDD5V Illuminates on +5V
D13 VFEED_POC Illuminates if VFEED_POC Power is ON
D14 VDDIO Illuminates on VDDIO Power
1.9 Enable and Reset
There are two device enable and reset/power-down options for the EVM.
• RC timing option: The C65 external capacitor and R17 pull-up resistor connected to the PDB pin ramp
time after the device is powered on.
• External control option: A push-button (S2) or SW1 position 2 is available for the manual control of the
PBD signal.