Texas Instruments DS90UB934-Q1, User Manual, Page: 8 / 37

Demo Board Connections
www.ti.com
8 SNLU220 – December 2016
Submit Documentation Feedback
Copyright © 2016, Texas Instruments Incorporated
Using the DS90UB934-Q1EVM Evaluation Module
(1)
Only set one ON.
Table 10. Mode SW-DIP4 - S1
(1)
REFERENCE MODE DESCRIPTION
S1.1 1 Reserved
S1.2 2 RAW12 / LF
S1.3 3 RAW12 / HF
S1.4 4 RAW10 (Default)
Table 11. Control SW-DIP4 - SW1
REFERENCE SIGNAL INPUT = L INPUT = H DESCRIPTION
SW1.1 BISTEN
For Normal operation
(Default)
BIST Mode enable Test Mode
SW1.2 RES Tied to GND (Default) N/A Reserved
SW1.3 SEL FPD-Link III on Port 0 (CN1)
(Default)
FPD-Link III on Port 1 (CN2) Port Select
SW1.4 PDB Device is powered down Device is enabled (Default) Power-down Mode
Table 12. LEDs
REFERENCE LED NAME DESCRIPTION
D2 GPIO0 Illuminates if GPIO0 is ON
D3 GPIO1 Illuminates if GPIO1 is ON
D4 GPIO2 Illuminates if GPIO2 is ON
D1 GPIO3/INTB Illuminates if GPIO3 is ON
D9 LOCK Illuminates if device is Locked to a serializer
D15 PASS Illuminates if device is receiving error free data
D11 VDD_EXT Illuminates if 12V Power is applied to DC-IN J24
D12 VDD5V Illuminates on +5V
D13 VFEED_POC Illuminates if VFEED_POC Power is ON
D14 VDDIO Illuminates on VDDIO Power
3.6 Enable and Reset
There are two device enable and reset/power-down options for the EVM.
• RC timing option: The C3 external capacitor and R17 pullup resistor connected to the PDB pin ramp
time after the device is powered on.
• External control option: A push-button (S2) or SW1 position 4 is available for the manual control of the
PBD signal.
4 ALP Software Setup
4.1 System Requirements
Operating System: Windows
®
7 64-bit
USB: USB2ANY
USB2ANY Firmware Version: 2.5.2.0
USB: Aardvark I
2
C/SPI host adapter
p/n TP240141