Texas Instruments DS560MB410EVM, User Manual, Page: 7 / 29

Figure 5-4. DS560MB410 Profile Prior to Establishing Communication
5.2.1 Establishing a Connection
1. Connect the computer to the DS560MB410 through a USB2ANY device and USB cable. If using a
DS560MB410EVM, then this is accomplished by connecting the included USB cable to the EVM and
computer. If using a stand alone USB2ANY device, then a connection can be made between the I2C pins on
the USB2ANY and the SMBus pins on the DS560MB410. A common ground connection is also required.
2. Ensure the DS560MB410 is in SMBus Target mode.
3. Select appropriate SMBus address by using the
Target Address menu.
4. Select appropriate USB2ANY by using the USB2ANY Details menu.
5. Click Apply to connect to the device. The status indicator at the bottom of SigCon Architect will turn green to
indicate a successful connection.
www.ti.com SigCon Architect
SNLU296A – DECEMBER 2022 – REVISED DECEMBER 2022
Submit Document Feedback
DS560MB410EVM 7
Copyright © 2022 Texas Instruments Incorporated