Texas Instruments DS560MB410EVM, User Manual, Page: 4 / 29

Table 4-1. Description of SMBus and EEPROM Connections (continued)
COMPONENT(S) NETS INCLUDED DESCRIPTION
J12 READ_EN_N Assert low to initiate EEPROM read in
SMBus controller mode (weak pull-up)
XU1 EEPROM 8-pin DIP Socket for EEPROM
J2 CAL_CLK_IN External 25 MHz Calibration Clock Input (for pin-
compatible Retimer only)
J1 CAL_CLK_OUT 25 MHz Calibration Clock Output (for pin compatible
Retimer only)
J9 VDD_3P3V 3.3 V for DC Power
J11 VDD_2P5V 2.5 V for DC Power
J7 GND Ground for DC Power
J22 USB Mini USB connection for EVM software control
Table 4-2. Test Point Connections (Output Voltage)
Component Name Description
TP1 GND Common Ground
TP2 VDD +2.5 V Input
TP5 GND Ground
TP3 VDD +3.3 V Input
5 SigCon Architect
The SigCon Architect software allows for simple configuration of the DS560MB410.
5.1 Installation
Prerequisites:
• SigCon Architect 3.0
1. Use your web browser to download the DS560MB410 SigCon Architect profile installer from the product
page on TI.com.
2. Once the installer has downloaded, extract the installer from the .zip file and run the executable file.
3. When the executable runs, a setup wizard will appear as shown in
Figure 5-1 . It is recommended to close
any running programs prior to proceeding.
SigCon Architect www.ti.com
4 DS560MB410EVM SNLU296A – DECEMBER 2022 – REVISED DECEMBER 2022
Submit Document Feedback
Copyright © 2022 Texas Instruments Incorporated