Texas Instruments DLP5532HBQ1EVM, User Manual, Page: 10 / 21

2 Quick Start
Use the following instructions to setup the DLP5532HBQ1EVM and PC for video input and control
communication.
2.1 Kit Assembly Instructions
A diagram of all connections is shown in Figure 2-1 .
1. Connect the controller to driver control interface flex cable to the controller PCB (J8) and the illumination
driver PCB (J201).
2. Connect the host SPI /I2C cable to the controller PCB (J2/J1) and the FTDI adapter. Connect the FTDI
adapter’s USB cable to PC.
3. Connect the controller power cable to the controller PCB (J11) and the illumination driver PCB (J202).
4. Connect the blue illumination output cable to the illumination driver PCB (J203) and then to the blue
illuminator in the optics system.
5. Connect the green illumination output cable to the illumination driver PCB (J2) and then to the green
illuminator in the optics system.
6. Connect the red illumination output cable to the illumination driver PCB (J1) and then to the red illuminator in
the optics system.
7. Connect the respective fan cables to the illumination driver PCB ports (J4, J5, J6) and then to the fans
themselves in the optics system.
8. Connect the photodiode cable to the controller PCB (J5) to a photodiode located in the illumination path of
the optics system.
9. Connect the Micro HDMI cable to the controller PCB (J3). Connect the Micro HDMI cable to PC HDMI port.
10. Connect the power input cable to the illumination driver PCB (J3).
Quick Start www.ti.com
10 DLP5532HBQ1EVM Evaluation Module DLPU108 – MAY 2022
Submit Document Feedback
Copyright © 2022 Texas Instruments Incorporated