3.10 Open the HSDC Software and Load the FPGA Image to the TSW14DL3200EVM
Use the following steps to open the HSDC software and load the FPGA image to the TSW14DL3200EVM:
1. Open the HSDC Pro software.
Click
OK
to confirm the serial number of the TSW14DL3200EVM device. If multiple TSWxxxxx boards are
connected, select the model and serial number for the one connected to the DAC12DL3200EVM. When the
EVM powers up, there is no firmware loaded in the FPGA. Click the
OK
button on the
No firmware. Please
select a device to load firmware into the board.
message.
Figure 3-5. No Firmware Loaded
2. Click on the
DAC
tab in the top right of the GUI.
In the device drop-down menu, select "DAC12DL3200_MODE2_12b_sync_istrb” as illustrated in
Setup Procedure
SBAU374 – MAY 2021
DAC12DL3200 Evaluation Module
11
Copyright © 2021 Texas Instruments Incorporated