10 Manual Information to the End User
The OEM integrator must be aware not to provide information to the end user regarding how to install or remove
this RF module in the user's manual of the end product. The end user manual must include all require regulatory
information and warnings as shown in this manual.
10.1 RF Function
The CC2564MODN is a dual-mode Bluetooth HCI module.
Note
The maximum RF power transmitted in each band is 10 dBm.
10.2 FCC or IC Certification and Statement
This device is intended for OEM integrators under the following conditions:
• The antenna must be installed such that 20 cm is maintained between the antenna and users.
• The transmitter module may not be co-located with any other transmitter or antenna.
• To comply with FCC or IC regulation limiting both maximum RF output power and human exposure to RF
radiation, the maximum antenna gain (including cable loss in mobile exposure conditions) must not exceed
-1.69 dBi.
In the event that these conditions cannot be met (for example, certain laptop configurations or co-location with
another transmitter), the FCC or IC authorization is no longer considered valid. The FCC or IC ID cannot be used
on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC or IC authorization.
10.2.1 FCC
The TI CC2564MODA module is certified for FCC as a single-modular transmitter. The module is a FCC-certified
radio module that carries a modular grant.
Note
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment. This device complies with Part 15 of the FCC rules.
Operation is subject to the following conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
CAUTION
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20 cm
between the radiator and your body.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from the one the receiver is connected to.
• Consult the dealer or an experienced radio or TV technician for help.
Manual Information to the End User
18
Dual-Mode Bluetooth
®
CC2564 Module Evaluation Board
SWRU390A – AUGUST 2014 – REVISED AUGUST 2021
Copyright © 2021 Texas Instruments Incorporated