![background image](http://html1.mh-extra.com/html/texas-instruments/ads5474/ads5474_user-manual_1095260015.webp)
12
Troubleshooting
in
Play
mode.
13
SP Devices Intellectual Property
www.ti.com
Troubleshooting
Problem
Remedy
GUI warns for not installed or activated FTDI Drivers when
If you did not select to pre-install FTDI Drivers during installation,
starting the
install FTDI Drivers separately or re-install the ADCaptureLab
application.
application and select to pre-install FTDI drivers.
If you have pre-installed the FTDI Drivers, you need to activate the
driver by plugging in a compatible powered board to the computer
over the USB.
No devices are found when scanning the USB by pressing
Check if a compatible board is plugged in via USB.
Find USB
Check if board is powered.
Devices
Try to push the onboard reset button. Press
Find USB Devices
again.
Try to turn the power off and on again. Press
Find USB Devices
again.
Restart the software, and try again.
Board is connected and found in list, but when trying to
Check if board is powered.
acquire board does not respond correctly.
Check that correct board format is selected in Setup Settings (5.1).
Try to push the onboard reset button. Press
Find USB Devices
again,
select board and retry.
Try to turn the power off and on again. Press
Find USB Devices
again, select board and retry.
Time series plot or FFT does not update when acquiring or
The plot which is not updating may be in
Pause
mode. Put the mouse
importing data
cursor in the top right of the plot window in question to enable the
toolbar. If the play symbol is visible (see inset), push it to set the plot
This evaluation board/kit contains intellectual property belonging to SP Devices, (SP Devices IP). SP
Devices retains all ownership rights in SP Devices IP and no license is granted under any patent right or
other intellectual property right of SP Devices except for use for engineering development, demonstration,
or evaluation purposes.
SLAU247 – August 2008
ADS5474 ADX Evaluation Board for Interleaving
15