www.ti.com
Software Control
• Low Speed Mode En:
Low speed mode enable or disable.
• Low Speed Mode ChA: Low speed mode for channel A.
• Low Speed Mode ChB: Low speed mode for channel B.
• LVDS Data Strength:
Set the data strength from this switch.
• LVDS Clkout Strength:
Set the output clock strength from this switch.
• CMOS Clk Strength:
Set CMOS output clock strength from this switch.
Figure 1. ADS58C28_ADS42xx_GUI Front Panel – Top Level
1.2.2
Advanced Level
Click on “Advanced” tab on the GUI to bring the advanced panel to the front. On this panel user can write
address and data of any register into the address/data boxes (as shown in
, “45” is address and
“4” is data). Press Enter on the key board once data is entered or click “Send All” button on the GUI to
send address and data from the boxes to ADC. The address and data are shown in the display box
located at right side of the panel. In addition, there is group of switches used for output offset functions,
SNRBoost pin overwrite (for ADS58C28), and a group of LEDs used to designate a custom test pattern.
3
SLAU333 – March 2011
ADS42xx EVM
© 2011, Texas Instruments Incorporated
