Install the High Speed Data Converter (HSDC) Pro Software
9
SLAU776 – May 2018
Copyright © 2018, Texas Instruments Incorporated
Setup Procedure
2.1
Install the High Speed Data Converter (HSDC) Pro Software
Download the most recent version of the HSDC Pro software from
www.ti.com/tool/dataconverterpro-sw
.
Follow the installation instructions to install the software.
2.2
Install the Configuration GUI Software
1. Download the configuration graphical user interface (GUI) software from the EVM tool folder at
http://www.ti.com/tool/ADC12DL3200EVM
.
2. Extract files from the compressed zip file.
3. Run the executable file (setup.exe), and follow the instructions.
2.3
Connect the EVM and TSW14DL3200EVM
With the power off, connect the ADC12DL3200EVM to the TSW14DL3200EVM through the FMC
connector as shown in
. Make sure that the standoffs provide the proper height for robust
connector connections.
2.4
Connect the Power Supplies to the Boards (Power Off)
1. Confirm that the power switch on the TSW14DL3200EVM is in the off position. Connect the power
cable to a 12-V DC (minimum 3-A) power supply. Make sure that the proper supply polarity by
confirming that the outer surface of the barrel connector is GND and the inner portion of the connector
is 12-V. Connect the power cable to the EVM power connector.
2. Confirm that the power switch on the ADC12DL3200EVM is in the off position. Connect the power
cable to a 5-V DC (minimum 3-A) power supply. Make sure the proper supply polarity by confirming
that the outer surface of the barrel connector is GND and the inner portion of the connector is 5-V.
Connect the power cable to the EVM power connector.
CAUTION
Make sure that the power connections to the EVMs are the correct polarity.
Failure to do so may result in immediate damage.
Make sure that the 12-V power supply is connected to the TSW14DL3200EVM
and not the ADC12DL3200EVM. Providing the ADC12DL3200EVM with 12-V
may result in immediate damage.
Leave the power switches in the off position until directed later.
