Tetra Pak COMET RC, Manual

Page: 39 / 118

CRC804BF 6-14
Tetra Pak
Hoyer
This station consists of a closing plate (Pos. 1, Fig.
6.16) mounted on the up/down slide. Loosen screws
(Pos. 3/4, Fig. 6.16) to adjust height and centre
crimping tool over slot, tightening the screws again
afterwards.
Correct adjustment is important to make sure that
lids are closed properly.
Fig. 6.16
This station consists of a sealing head fixed on the
up/down slide. Loosen the screw (Pos. 1, Fig.
6.17) to centre it over the lid, then tighten the screw
again.
Correct adjustment is important to ensure that lids
are sealed properly.
The temperature of the sealing head may be adjusted
using the appropriate control (Pos. 4, Fig. 6.20)
on the control panel (by pressing “F” and then + to
increase temperature or - to decrease it).
6.3.6 Lid closing station
6.3.7 Lid sealing station
Fig. 6.17
3
1
4
2
1