Teton Grill 720-0430, Use And Care Manual

Page: 18 / 38

GRILL LIGHTING INSTRUCTIONS
TO LIGHT THE GRILL BURNER:
Make sure all knobs are “OFF” then turn on the gas
supply from the LP tank. Always keep your face and
body as far from the grill as possible when lighting.
Your stainless steel grill has an exclusive patented
built-in ignition. The igniter is built in to the valve. To
ignite each burner simply push and turn the control
knobs to the “IGNITE/HI” setting, you will hear the
valve click as it sends a spark to the pilot flame. If
the burner does not light wait 5 minutes for any
excess gas to dissipate and then retry.
WARNING: Always keep your face and body
as far away from the burner as possible
when lighting.
TO LIGHT THE SIDE BURNER
To light the side burner, remove any cooking
utensils from the burner grate. Push and turn the
control knob counterclockwise to the “IGNITE/HI”
position. If the burner does not light, turn the control
knob to “OFF”. If the smell of gas is detected and
the igniter is not functioning, immediately turn the
control knob “OFF”. Allow 5 minutes for any
accumulated gas to dissipate. If the side burner
igniter is not functioning, see the following section
for match lighting.
TO MATCH LIGHT THE GRILL
If the burner will not light after several attempts then the
burner can be match lit.
Lighting rod instruction:
Match light extension rod
Use this device to match light your burners
Simply place a lighted match between the coils on the
end of the extension rod and hold next to the burner to
ignite.
If you’ve just attempted to light the burner with the
igniter, allow 5 minutes for any accumulated gas to
dissipate. Keep your face and hands as far away
from the grill as possible. Insert a lit match attached
to the lighting rod through the cooking grids to the
burner.(see next page) Press the control knob and
rotate left to the IGNITE/HI setting, continue to press
the knob until the burner ignites. Burner should light
immediately. If the burner does not light in 4
seconds turn the knob off, wait 5 minutes and try
again.
TO MATCH LIGHT THE SIDE BURNER
Hold a lit extended match or lighter near the side
burner ports, turn the control knob
counterclockwise to “IGNITE/HI”. Move your hand
immediately once the burner is lit. Rotate the
control knob to the desired setting.
TO LIGHT THE ROTISSERIE BURNER:
Open the lid; push and turn the knob to the
“IGNITE/ON” position. While holding in the knob,
push electronic igniter to light the rotisserie burner.
Once the burner is lit, continue to hold in for
another 15 seconds to be sure the burner stays lit.
If the burner does not light, turn the control knob to
“OFF”. If the igniter does not function, follow the
instruction above for match lighting
Keep a spray bottle of soapy water
near the gas supply valve and check
the connections before each use.
Do not attempt to light the grill if odor
of gas is present. Call for service
1-800-913-8999
17