QUALITY GAS EQUIPMENT
P. +61 2 9737 9937 | E. [email protected] | W. www.tesuco.com.au
Sparki
Instructions for Models
SPT031, SPT051 & SPT101
For SPT031 & SPT051 Magnetic Base
Attach Sparki to a steel surface. The magnet is very strong
and will hold in any position.
Place cutting or gouging
nozzle or welding/brazing
tip over top.
Turn on the fuel gas and press the tip down into the top of
the Sparki unit. When the piezo clicks the flame will ignite.
Pull up and adjust the oxygen and fuel gas for the correct
cutting, gouging, welding or brazing flame.
For SPT101 100 mm Steel Base
This model is designed to be permanently attached to a
work bench or wall with screws or by welding.
Follow steps 2, 3 and 4 for use.
1
2
1
3
4
5
CAUTION
Check oxygen fuel
cutting/welding equipment
for leaks prior to lighting.
Always use igniter in
ventilated areas.
Cutting and welding
equipment must only
be used by experienced
competent operators.
Ensure before lighting that
there are no combustible
materials in the area.
The magnet in the Sparki igniter is very strong, damage may
occur if incorrectly removed from the steel surface. When
removing Sparki from a steel surface, do not try to lift directly
off, roll to the side, so that the magnet removes easily.
