TESTO 350 Maritime V2, Instruction Manual

Page: 52 / 106

6 Using the product
52
> [ ] → Device settings → [OK] → Dilution → [OK]
1. Select to dilute all (x5) : [ ] → [Change] .
2. Select setting: [On] / [Off] .
3. Confirm the entry:
[OK]
.
6.1.2.2. Measurement view
(only available via Meas. Box tab)
The parameters / units and the display representation (number of
readings displayed per display page) can be set.
The settings are only valid for the currently chosen combination of
application and measurement type, which is indicated by the
symbol (application) and the text (measurement type) in the info
field.
Only those parameters and units that are activated in the
reading display appear in the reading display, in the saved
measurement records and on the record printouts.
Readings not listed in the reading display are not recorded
or stored either. Before carrying out measurements, set up
the reading display so that the required measurement
parameters and units are enabled.
Total overview of selectable parameters and units (available
selection depends on the chosen application / measurement type):
Display Measurement parameter
FT Flue gas temperature
AT Combustion air temperature
HCT Heat carrier temperature
Δp
Differential pressure
Δp1 Differential pressure 1 (flue gas + m/s)
Δp2 Differential pressure 2 (flue gas + Δ P)
Draught Flue draught
Pabs Absolute pressure
Pump Pumping capacity
O2 Oxygen
CO2
Carbon dioxide
CO2max maximal carbon dioxide content
Effn Efficiency