6 Using the App
15
6.5.
testo 115i/915i - Surface increment
Surface probes withdraw heat from the measured surface immediately
after the initial contact. This makes the measurement result lower than
the true surface temperature without the probe (or the reverse if the
surface is colder than the environment). This effect can be corrected by
an increment in % of the reading.
The probe is connected to the SMART App.
1
Click on
.
Main menu opens.
2
Click on
Sensors
.
The Sensors menu opens.
3
Click on the required sensor.
Information is displayed about the model, order number, serial number
and firmware version.
4
Click on the
Settings
tab.
The settings window opens.
5
Click on
Use surface increment
.
6
Enable
Activate surface increment
using the slider.
6.6.
List, graphic diagram and table view
The available readings can be displayed in different ways in the
various views.
•
List view
Displays the readings transmitted by the Smart Probe in the
form of a list. Readings from all connected Smart Probes are
displayed here.
•
Graphic diagram view
The graphical progression of up to four different readings can
be displayed. Tap on a reading above the diagram to select the
readings to be displayed.
