TestEquity FOV Series, Installation & Operation Manual

Page: 15 / 43

15 | P a g e
INSTALLATION
P
OWER
S
OURCE
R
EQUIREMENTS
When selecting a location for the unit, verify that each of the following requirements is satisfied:
Power Source: The wall power outlet must meet the power requirements listed on the unit data
plate. These units are intended for 110 – 120 VAC 50/60 Hz applications at the following
amperages:
FOV2 12.0 Amps ; FOV3 14.0 Amps ; FOV5 14 Amps
•
Wall power sources must be protective earth grounded and single phase .
•
Wall power sources must conform to all national and local electrical codes.
•
Supplied voltage must not vary more than 10% from the data plate rating
. Damage to
the unit may result if supplied voltage varies more than 10%.
•
The recommended wall circuit breakers for these units are 15 amps.
•
Use a separate circuit to prevent loss of product due to overloading or circuit failure. The
circuit must match or exceed the amperage requirement listed on the unit the data plate.
Power Cord: The unit comes provided with a 125 volt, 15Amp, 9ft 5 in (2.86m) NEMA 5-15P power
cord.
•
The unit must be positioned so that all end-users can quickly unplug the oven in the event
of an emergency.
Fuse: Each oven ships with a 16 amp 250V 5x20mm fuse installed in the power cord inlet.
•
The fuse must be installed and intact for the unit to operate.
•
Always find and fix the cause of a blown fuse prior to putting the unit back into operation.
L
IFTING AND
H
ANDLING
The oven is heavy. Use appropriate lifting devices that are sufficiently rated for these loads. Follow
these guidelines when lifting the oven:
•
Lift the oven only from its bottom surface.
•
Doors, handles, and knobs are not adequate for lifting or stabilization.
•
Restrain the oven completely while lifting or transporting so it cannot tip.
•
Remove all moving parts, such as shelves and trays, and lock doors in the closed position
during transfers to prevent shifting and damage.