6/10
5
Operating Instructions
Switching on and off:
The probe measures radon concentration autonomously and communicates in wireless network only if
the switch is in position „I“( switch on). The switching on is signalized by LED diode „STAT“ according chart
below.
If the switch is in position „0“ (switch off) the probe doesn´t measure radon concentration and doesn´t
communicate in wireless network. In switching off mode the probe only keeps running real time for correct
date and time of records in case of switch it on again. By switching off the probe doesn´t lose previous
records of measurement. The switching on is signalized by LED diode „STAT“ according chart below.
Download data from probe over USB is possible only if switch is in position „I“( switch on).
LED diode „STAT“:
It signalizes status radon probe according to following chart:
Color
Description
Green blink 3x
Radon probe has just been turned on.
Green blink after 5s
Radon probe measures and works correctly
Yellow blink 3x
Radon probe has just been turned off.
Green
/
Yellow
blink after 5s
Radon probe measures but troubles are occur. – especially low capacity of
accumulator. Warnings and errors are shown in PC application.
No light, No blinking
Radon probe doesn´t measure or accumulator is empty or device is damaged.
Charging process of accumulator is described in chapter „Basic Maintenance/
Accumulator charging“
Power supply:
According to operation method the radon probe can be supplied:
1)
By internal accumulator for portable use – Radon probe includes internal accumulator which is
able to ensure autonomous operation of probe for more than 12 months without charging.
Depends on climatic condition of probe use. Accumulator is charged with USB port and provided
USB cable. The USB cable is possible to connect to PC or to delivered power adapter. Status of
accumulator and charging process are described in paragraph ´Basic Maintenance/Accumulator
charging´
2)
By mains power supply 230V/50Hz for stationary use – Radon probe is permanently supplied by
delivered power adapter. Power adapter is connected to probe via provided USB cable. In case of
blackout internal accumulator ensures UPS function.
Configuration:
Setting and configuration are realized by usbRADONview application. UsbRADONview application,
drivers and user manual with detail configuration description are free downloaded on website:
http://www.tesla.cz/en/ke-stazeni/
6
Display Operation
Built-in display can continuous show measured result and basic parameters of probe. By reason of
power saving the display isnt switched on permanently but it is switched on by pushing of button below
display. By next pushing of button is changed screen on another in cyclic order. Approximately after 1
minute without pushing of the button the display is automatically switched off.
