The commissioning process for Wall Connector enables easy configuration of circuit breaker size, Wi-Fi
connectivity, and power sharing options.
1. Turn on Wall Connector's corresponding branch breaker to energize the unit.
On startup, Wall Connector will display green LEDs for 10 seconds to indicate the maximum circuit
breaker it is configured for.
2. Use a Wi-Fi-enabled device such as a smart phone to connect to the SSID Wi-Fi signal broadcasted
by the Wall Connector. Joining the Wall Connector network can be done by scanning the sticker QR
code on the Quickstart Guide cover page, or by manually selecting the network and typing in the
WPA2 password (found on the sticker on the Quickstart Guide cover page).
NOTE:
The Wi-Fi network will only broadcast for 5 minutes. To have the Wall Connector broadcast
the SSID again, hold the button on the charging handle for 5 seconds or turn the circuit breaker off,
then on again.
NOTE:
If you are unable to connect to the Wall Connector SSID, turn off the cellular data on your
mobile device and try again.
3. Scan the QR code below with the device that is connected to the Wall Connector to access the web
browser commissioning interface. Alternatively, manually type the URL address (http://192.168.92.1)
into the web browser.
4. Follow the onscreen commissioning steps on the web browser to assign Wall Connector to its own
circuit breaker and connect it to the local site Wi-Fi network.
COMMISSIONING PROCEDURE
22
Gen 3 Wall Connector Manual
Summary of Contents for Gen 3 Wall Connector
Page 1: ...Gen 3 Wall Connector Manual 48A Single Phase...
Page 2: ......