Tescom MTP200B, Operating Manual

Page: 47 / 172

MTP200B WLAN Signal Analyzer Set-up
31
Table 7-1 WLAN 802.11a/g/n Channel Band
Standard Channel Number Frequency
802.11g(OFDM) 1 to 14 2412 MHz to 2484 MHz
802.11a 34, 36, 38, 40, 42, 44, 46, 48, 52, 56, 60 ,64
100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 14
0, 149, 153, 157, 161,165
4900 MHz to 5850 MHz
802.11n
(20 MHz
channel ba
ndwidth)
2.4 GHz 1 to 14 2412 MHz to 2484 MHz
5 GHz 34, 36, 38, 40, 42, 44, 46, 48, 52, 56, 60 ,64
100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 14
0, 149, 153, 157, 161,165
4900 MHz to 5850 MHz
7.2.3 NUM_FRAME Setting
Set the number of frames to be measured for each measurement. The higher the number is, the longe
r the measurement time. Enter the minimum value required for reliable measurement.
●
Select ANL (M2) → CONFIG → NUM_FRAME tab -> Enter the value between 1 ~ 100 (Default value: 10)
7.2.4 Repetition Mode Setting
MTP200B provides two REPETITION mode, SINGLE and CONTINOUS.
●
Select ANL (M2) → CONFIG → REPETITION → SINGLE or CONTINOUS tab.
Table 7-2 REPETITION mode set-up
REPETITION Description
SINGLE One time measurement mode (It stops after measures once by number of WLAN p
acket that is set)
CONTINOUS(Default) Continuous (It measures repetitively by number of WLAN packet that is set)
The default value of Repetition mode is CONTINUOUS. However, as the main purpose of prod
uction program is to decide whether it satisfies the specs, so it is recommended to use under SI
NGLE mode.