Instruction manual for MH & MH+M
146
This page will be displayed. It is now possible to insert tolerances (but not mandatory) then
to save the sequence pressing
.the next step is to enter the program name and confirm
it to end the process and save the data in the USB stick.
A sequence that has been done in ST1 mode will be saved with *.st1
format. It is the same for ST2. For this case the *.st2 format will be used.
On the top right side of the window, the number of still available
characters as well as the number of total characters are displayed.
22.6 Sequence loading
Loading a measurement sequence from USB stick does not imply that i twill be automatically
run. Indeed, the loading only recalls the sequence and places it in corresponding memory
(ST1 or ST2).
The blocks from the memory are automatically overwritten when loading a
program from the USB stick. It is not possible to get these blocks back.
A sequence can be recalled whenever from ST1 or ST2 mode pressing
from control
panel then selecting the programs management option.
Prior to load a ST 2 sequence from your USB stick, it is not mandatory to
have your probe being calibrated. You can directly access the program
management options from the probe calibration page pressing button.
