15
Turning Monitor On and Off
The power switch, outlined in red below, is at the bottom of the OSD keypad on the back of the monitor,
left side as viewed from the front.
Connect the monitor to DC power. The monitor should come on within 10 seconds.
If the monitor does not come on within 10 seconds, press the power button The monitor should power
on within 5 seconds.
When the monitor is on, pressing the Power button will open a pop-up that asks
, “Do you want to turn
off?” If yes, press the Power button again. Another popup says, “Please press the power button again.”
Press the Power button again to turn the monitor off.
Note:
If there is no video input signal for a preset period, the monitor will automatically go into standby
mode. Allow up to 10 seconds for the video to reappear after the signal is reapplied.
