Page
69
of
76
13
T-RAC II Wifi setup
Each T-RAC II Wifi device needs to be set-up separately in order to communicate with
the wireless access point. To do so, proceed as follows
1.
Put the IP-address of an Ethernet port of a PC on 192.168.1.100 and the subnet
mask on 255.255.255.0.
2.
Connect the Ethernet port of T-RAC II which is marked as follows directly to
the Ethernet port of the PC.
[NOTE] If the PC
doesn’
t support Auto-MDIX, a crossover cable is needed for this.
3.
Switch-on T-RAC II Wifi.
4.
On the PC, open a web browser and surf to 192.168.1.253. Following screen
should be shown:
5.
Enter ‘dpac’ in both the username and password fill
-in box and press enter.
Summary of Contents for T-RAC II
