Terumo BCT Quantum Cell Expansion System, Operator'S Manual

Page: 25 / 204

Table 2-3: Components inside the incubator
Location Component Function
1 Mounting plate Contains the pumps, the valves, the rocker and rocker arm, the external
mounting clips, the internal mounting clips, and all the fluid detectors.
2 External mounting clips Hold the tubing organizer in place. The external mounting clips are located
along the perimeter of the mounting plate.
3 Internal mounting clips Hold the tubing organizer in place. The internal mounting clips are located
in the center of the mounting plate.
4 Pegs Hold the tubing line guide in place.
5 Rocker arm Holds the bioreactor in place in the incubator.
6 Rocker Rotates the bioreactor to facilitate priming and to keep cells from settling in
the IC inlet and IC outlet headers. The rocker is located on the device and
not on the cell expansion set.
7 Spill tray (containing the
leak detector) Captures fluid from leaks that occur inside the incubator and contains the
leak detector, which detects the presence of a fluid leak inside the
incubator.
8 Gas quick disconnect Allows the gas supply to flow into the cell expansion set via the gas inlet
line.
Introduction
2-6 Quantum
®
Cell Expansion System • Operator's Manual for Software Version 2.1