Terumo BCT Quantum Cell Expansion System, Operator'S Manual

Page: 107 / 204

Unload Cell Expansion Set
The purpose of this task is for the system to open all the valves, which allows you to unload the cell
expansion set.
Note: All seals should be double seals.
When the task is completed:
1. Seal and disconnect the lines on all the bags.
2. Touch
Task
.
3. Touch
Set Management
.
4. Touch
Unload Cell Expansion Set
.
The Setup: Unload Cell Expansion Set screen appears.
5. Touch
Start
.
The Unload Cell Expansion Set status screen appears and includes a progress bar. The system opens
all the valves.
6. Open the incubator door.
7. Unlock the rotor latches, and open the rotor covers on the pumps.
8. Remove the tubing from the pumps.
9. Disconnect the gas inlet line from the gas quick disconnect by pressing down on the silver button on
the top of the gas inlet line.
10. Turn off the external gas supply.
11. Remove the bioreactor from the rocker arm.
12. Remove the tubing line guide from the pegs.
13. Grasp the top internal mounting clip, bend it to the left, and rotate it a quarter turn clockwise to
unlatch the clip from the tubing organizer.
14. Grasp the bottom internal mounting clip, bend it to the left, and rotate it a quarter turn clockwise to
unlatch the clip from the tubing organizer.
15. Unlock the five external mounting clips, and wiggle the tubing organizer in and out while pulling it
towards yourself to pull it off the mounting plate.
16. Dispose of the cell expansion set properly.
17. Close the rotor covers, and lock the rotor latches on all the pumps.
18. Touch
Finish
when you are ready to complete the task.
19. Touch
Yes
.
The home screen appears, the system changes to an idle state, and the status line displays Idle.
Set Management Tasks
7-12 Quantum
®
Cell Expansion System • Operator's Manual for Software Version 2.1