TERRY Melody 2 hydraulic MK2, Installation Manual

Page: 9 / 60

Melody 2 Hydraulic MK2 Installation Manual - Issue f
9
NOTES
4. Cutting of the Main Uprights and Lower Guides
Use a jigsaw or metal cutting saw to cut uprights and guides. Ensure burs are
removed and treat cuts before fi tting as follows: Seal all exposed edges using
a touch-up can. Seal further with Supatrol once the paint has dried.
RH Main Upright: (60 x 60 Box Section)

Cut the upright using the following formula:
Measure from the baseplate top surface to the upper
level plinth top surface (Distance X).
For a 2m lift:
2000 – Distance X = calculated length (amount to cut
off).
For a 3m lift:
3000 – Distance X = calculated length (amount to cut
off).
Now cut the calculated length off the bottom of the
lower guides and main uprights
OR In the case of a
3m lift, cut the calculated amount off the bottom of the
lower extension box section.
LH Main Upright: (60 x 60 Box Section)

Cut the calculated length PLUS 260mm off the LH Main Upright. This will
place the cut at 300mm above the base plate, which is the point where the
lower gate enable switch must roll off to enable the car gate.
Continued Over: