TERRY Melody 2 hydraulic MK2, Installation Manual

Page: 16 / 60

Melody 2 Hydraulic MK2 Installation Manual - Issue f
16

Lay out the chain drive assembly ensuring that no dirt or grit gets in the links, and attach
the Anti Creep unit as detailed above. The chains now need to be cut to length.

On the chain equaliser assembly, remove the chain from the swivelling chain brackets -
see B.

Attatch the chain equaliser assembly to the top right hand guide as normal, ensuring the
minimum engagement of the top adjustment bolt. - see A.

Fit the chain assembly, feeding it into the right hand guide. Sit this assembly on a suitable
packer on the baseplate (around 250mm high). Fit four M8 x 30mm countersunk allen
bolts to secure the chain brackets to the baseplate.
IMPORTANT:
The top bolt (M12x100 set screw, 12.9 grade) must
be engaged by a minimum of 30mm, when the lift is in
operation
This means that a absolute maximum distance of 64mm is
allowed between the underside of the top plate and the top
of the tapped boss of the chain hanger. (See diagram)
16. Carriage Assembly
The following diagrams and notes describe in detail assembly of the flat-packed carriage.
Follow them carefully and ensure all bolts and screws are correctly tightened.

Fit the side trim covers with glass clamps pre-attached.

Remove the bottom glass clamp on the gate hinge side handrail and slide handrail
through gate hinge tubes. Replace glass clamp afterwards. Then fix whole assembly to
carriage.

Fit the handrail assemblies using the fi xings provided.

Once the Platform is attached to the chain
drive assembly, pull each chain through the
appropriate chain equaliser attachment
block (top right hand guide) to establish
where each chain needs to be cut (see B).

Cut the chains and re-attach to the swivelling
blocks.

Adjust the top bolt to level the platform as normal
MAX 64mm
B
A