TERRY Melody 2 hydraulic MK2, Installation Manual

Page: 10 / 60

Melody 2 Hydraulic MK2 Installation Manual - Issue f
Guides

Cut the calculated length off the lower LH and RH Guides.

Take the off- cut from the lower left hand guide and copy the outline of
the ram cut-out onto to remaining guide. Either use a jigsaw or metal
cutting saw to create the guide cut-out. Seal all exposed edges using a
touch-up can. Seal further with Supatrol once the paint has dried.
10
NOTES
5. Upper Left Hand Guide Box Section

Attach the upper left hand guide and top cap to the left hand upright. If the
lift is a 3m model, an upper extension box section needs to be fixed onto
the top end of each upright. This is secured with M8 bolts inside and M8
countersunk bolts from above. Use M6 countersunk bolts in the sides.

A new square shaped washer is needed to locate the guide fixing bolt
centrally in the slot in the guide bracket when the guides are being attached.

Place washer into the bracket with the hole and slot aligned, the washer
can go in either way up with the flat side against the inside face of the guide
bracket.
 
f guide adjustment is required move this washer and replace with the M10
washer provided.