Email: [email protected] www.terratekintl.com
ACL Group (Intl) Ltd
17
Grinding
We recommend that you use the fine-grained grinding wheel for fine grinding work and
the coarse-grained grinding wheel for coarse grinding work.
Place the work piece onto the work piece support (7) and slowly guide the work piece towards
the grinding wheel (5) at the desired angle to the point where the work piece and grinding wheel
make contact.
Move the work piece slightly back and forth to produce an optimal grinding result. This way the
grinding wheel (5) is evenly worn. Allow the work piece to cool between grinding.
Warning:
Always pull out the mains power plug before starting any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with compressed air at low pressure.
We recommend that you clean the device immediately after each time you have finished using it.
Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water
can seeps into the device.
Maintenance
There are no parts inside the equipment which require additional maintenance.
Maintenance And Cleaning
6
Disposal
Power tools, accessories and packaging should be sorted for environmentally-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According to the European Directive 2002/96/EC on waste electrical and
electronic equipment and its incorporation into national right, products
that are no longer suitable for use must beseparately collected and sent
for recovery in an environmentally-friendly manner.
