Terrasat Rx 1+1, Operation Manual

Page: 56 / 174

3-20
|
Installation
feed, an optional Tx reject filter, and a dummy load. This can be seen in Figure F.3 on
page F-4 .
Connect a section of flexible waveguide between the Rx port of the waveguide switch
to the orthogonal mode transducer (OMT) port or the optional Rx reject filter. The
waveguide should be attached to the antenna feed according to the manufacturer's
instructions. Use proper gasketing methods to prevent water entry and subsequent
damage.
Configuration without IFU
1. Connect the IFL coaxial cable between the J1 (Rx L-band) connector and the
modem.
2. Connect the coaxial cable between the LNB (Rx L-band) and the L-band Rx input
of the modem.
3. Connect the M&C cable between the Rx 1+1 J1 connector (M&C) and the
appropriate M&C computer or LAN connection.
4. Connect the DC cable between the outdoor PSUI J2 connector (DC output), as
appropriate, and the J3 connector (DC Input).
5. Connect the AC cable between the PSUI J1 connector (AC input) and the AC
power source.
Other Connections
1. Connect the M&C cable between the Rx 1+1 J1 (M&C) and the appropriate M&C
computer or LAN connection.
2. Connect the DC cable between the outdoor PSUI J2 (DC Output), as appropriate,
and the J3 (DC Input). Low power units can be supplied from the Modem or the
IFU through the coaxial cable to the Rx 1+1 system.
3. Connect the AC cable between the PSUI J1 (AC Input) and the AC power source.
WARNING
The output of the IBUC is microwave power.
Never look into the waveguide nor put your
head into the path of the beam which goes up
to the satellite.