We reserve the right of changing these instructions without special prior notification
TMS-UT-0709-Z07-5
3
3. Installation
3.1. Important warnings
THE GUARANTEE SHALL
NOT BE ACCEPTED IF THE
FOLLOWING WAS NOT
OBSERVED:
•
THE BOILER SHOULD BE PUT INTO
OPERATION BY THE AUTHORIZED SERVICE,
•
THE ENCLOSED IMPURITIES COLLECTOR
SHOULD BE BUILT IN ON THE STARTING LINE
OF CENTRAL HEATING AND INLET COLD
SANITARY WATER,
•
PRIOR TO CONNECTING THE BOILER TO THE
SANITARY WATER LINE, PIPES SHOULD BE
CLEANED IN ORDER TO AVOID THE
BLOCKAGE OF THE EXCHANGER.
THE LIST OF AUTHORIZED SERVICES IS ON THE
BACK OF THE LETTER OF GUARANTEE
THE BOILER SHOULD NOT BE INSTALLED ON
PLACEC WHERE THERE IS A DANGER OF BEING
PORING OVER WITH WATER OR A DANGER OF
SINKING.
IN AREAS WITH STRONG CONCENTRATION OF
LIME IT IS RECOMMENDED TO BUILD IN A
MAGNETIC OR ELECTROMAGNETIC LIME
BREAKER ON THE INLET LINE OF SANITARY
WATER ON THE BOILER.
3.2. Assembly
TERMO
-Kombi is foreseen for the wall assembly and
for the easier assembly, on the backside there is
foreseen the suspension support. For the suspension
you may use metal wall plugs with the screw M8 or
M10 or stronger plastic wall plugs – diana screws.
Precise dimensions of boilers are given in the
7.
Technical specification
Filling and emptying valve is delivered together
with the boiler and should be assembled at the
installation.
If possible, the boiler should be assembled to the
lowest point in relation to installation. In this way we
are protecting the boiler from air appearance, which
may leave heaters without water that could result in
their burning through.
Minimum distances at assembly
Disassembly schema