36
8.3. Adjusting the top plate
If you wish to adjust the height of the top plate or if it tilts a bit, it can be lifted and the nuts un-
der the top plate screw up and down to achieve the desired result. Read section 13.5.
8.4 Convection heat or Heat storage
You decide if you want the faster convection heat in your room or if a part of the heat shall be
stored for later release.
The choice between these two options is yours, and you change the setting on the back of the
stove, by changing the position of the two handles. (Left and right)
If both handles are pulled out, away from the stove, it is set for max. convection heat.
If both handles are pushed towards the stove, it is set for max. Heat storage.
9.0. Warranty
9.1. 5 Year warranty
If defects/faults are ascertained, use of the wood burner must be stopped immediately and the
dealer contacted.
Provided normal operation of the wood burner, TermaTech offers a 5 year warranty on material
and manufacturing faults on the load-bearing frame, exclusive of the combustion chamber.
9.2. Combustion chamber The following is not covered by the warranty
Combustion chamber, cast iron parts (bottom, door, grate) insulation material (vermiculite plates)
smoke deflector plates, glass, gaskets, the closing mechanism/handle and the handle.
9.3. Exterior parts The following is not covered by the warranty
Varnished plates/surfaces, stone facings, glazed tiles, concrete and glass, as well as the closing
mechanism/handle and magnets.
9.4. The warranty does not cover faults which are due to:
•
If the user/mounting guide is not being followed
•
The mounting has been carried out incorrectly
•
Overheating / deterioration of materials, caused by the use of example the incorrect type of
of fuel, petroleum coke or too much fuel
•
that the product has been connected to a chimney with poor drawing qualities. For example
chimneys that are too short or are leaking.
•
The product being positioned or has been positioned/kept in unheated or damp surroundings.
•
The product being in bad repair or not maintained according to the instructions.
•
Normal wear and tear of wearing parts/expendable parts as well as the varnish.
•
Similar circumstances which are not due to material or manufacturing faults.
The lesser defects below, which cannot support any claim, can occur in the product:
•
Naturally occurring variations in the colour nuances and marbling on the soapstone, sandsto-
ne and other stone cladding.
•
Sounds which occur during burning are normal. This occurs when the metal expands and
retracts.
If a fault occurs during delivery to the customer or if such fault arises during the warranty period
which is covered by this warranty, TermaTech A/S agree to send a suitable replacement part free
of charge to rectify the fault. Any additional obligation of TermaTech A/S to remedy the fault, for
example in the form of installation of the replacement part does not exist.
In addition the purchaser has, apart from the right to a replacement part, no right to either
direct or indirect damages.
Repairs of faults or replacements of parts on the product does not extend the product or replace-
ment parts warranty period. Neither does a new warranty period begin for the product or for the
replaced part.
Apart from the above warranty rules, the consumer also has those rights which are evident from
the obligatory consumer regulation.
9.5. Review
Any fault or defect must be examined by the dealer who has sold the product.
The purchaser must be able to prove that the product was purchased via the dealer and when it
was bought, in the form of an invoice/receipt. The purchaser must specify the model and produc-
tion number which is stated on the product. If the purchaser wishes to refer to a fault, the dealer
must be informed within 14 days of the fault being detected.
9.6 Warranty & Safety
Any unauthorized changes to the wood-burning stove will be viewed as structural change and
thereby the warranty will be void. Safety is also jeopardized.
