Terex TL160, Operating Manual

Page: 30 / 114

Technical Specifications 3
30/112 TL160 Operating Manual 12.9.08 Version 1.0
3.9.2 Fuel, lubricant, and coolant specifications
Prescribed fuels, lubricants, and coolants
for Central Europe
Application Code
designation
according to
Bi
1
Designation Specification, standards,
Quality
Remarks
Engine – Diesel fuel EN 590
ASTM D975 1-D / 2-D
Attention
Before using RME fuels
(rape oil methyl ester), it is
essential to consult your
responsible Terex dealer
for further details.
Engine EO 1540 A Engine oil SAE 15W-40
API CF4
ACEA E3 or E2
See also engine manufacturer's
Operating Manual.
Hydraulic
system HYD 1040 Hydraulic oil or
multi-grade
engine oil
HVLP 46
or
SAE 10W-40
The following viscosity limit values
must be observed (according to
ASTM 445):
at 100 °C min. 8 mm
2
/
s
(cSt)
at –10 °C approx. 1500 mm
2
/
s
(cSt)
BIO-E-HYD-
HEES
Biodegradable
hydraulic oil on
synthetic ester
base
Filling according to customer
specifications. Brand label on
machine.
The same viscosity specifications
apply as for mineral hydraulic oils.
Machine damage
caused by non-mixable bio
oils.
• Do not mix bio oils from
different manufacturers.
Attention
When changing from
mineral to biodegradable
hydraulic oils, the tank and
hydraulic system must be
completely drained,
cleaned and flushed.
For further details before
changing oils, please
consult your responsible
Terex dealer.
Axles,
Wheel hubs GO 90 LS Transmission oil SAE 85W-90LS
API-GL 5
Alternative recommendations
SAE 90LS
SAE 80W-90LS
Lubricating
points MPG-A Multi-purpose,
lithium-soap
based grease K2K-30
DIN 51825
Cooler Mixture of
water, additives
and glycol
Machine damage
due to incorrect coolant
and mix proportions.
Observe the information on
the cooling system given in
the engine manufacturer's
Operating and
Maintenance Manual.
The antifreeze is factory-set to
approx. -25 °C.
Tab. 11 Fuel, lubricant, and coolant specifications
1
In conformity with the regulation lubricants of the Main Association of the German Building Industry e. V.