IV.
START THE ENGINE / GENERATOR SET
A. CAUTION:
Ensure the circuit breakers are turned “OFF”. This prevents the engine from starting under
load and prevents electrical equipment from being subjected to improper voltage and frequency.
B.
Check the oil, fuel, and coolant (if liquid cooled) levels. If the fuel tank is empty, it may be necessary to
bleed the fuel line after filling the tank (see engine instruction book for procedure).
C.
Turn the ignition switch to the “RUN” position (see diagram below). Press the preheat push button for a
maximum of 7 seconds.
Do not engage the preheat button longer than the time specified or damage
may occur.
D.
Turn the ignition switch to the “START” position to engage the engine. After the engine starts, release
the switch so that it returns to the “RUN” position. Let the engine come up to speed and stabilize (re-
view the engine operating procedures in the manufacturer’s handbook).
E.
Turn on the main circuit breaker.
V.
TURN ON THE FLOODLIGHTS
A.
Turn the circuit breakers “ON” and check to insure all lamps come on. Allow a minimum of two (2)
minutes for lamps to reach full luminance.
B.
If required, rotate the tower to aim the lights as desired. Tighten the tower rotating locking bolt.
C.
Adjust the tower vertically and adjust lighting direction of individual fixtures if required.
VI.
LOWERING THE TOWER TO TRAVELING POSITION
A.
Loosen rotating lock.
B.
Using the winch, telescope the tower down to its fully retracted position until the telescoping locking pin
snaps into place.
C.
Insert manual locking device.
D.
CAUTION:
Ensure that the telescoping locking pin locks before pulling the tower locking pin at the
bottom of the pivot post. This ensures the tower is completely lowered and cannot be damaged by
telescoping out while in the travel position.
E.
Rotate the tower so that the groove in the galvanized ring at the pivot is pointing to the rear of the trailer
so that the tower can be lowered into the travel position.
12
Discount-Equipment.com
Summary of Contents for Series AL4000
