Terex Genie Z-45/25 Bi-Energy, Service And Repair Manual

Page: 38 / 143

Service and Repair Manual July 2021
Platform Components
26 Z ® -45/25 • Z ® -45/25J Part No. 1312350GT
6 Move the function enable toggle switch to
either side and hold the platform rotate toggle
switch to the right position until the platform is
fully rotated to the right. Continue holding the
toggle switch until air stops coming out of the
bleed screw. Close the bleed screw.
Crushing hazard. Keep clear of
the platform during rotation.
7 Clean up any oil that may have spilled.
Properly discard the used oil.
8 Rotate the platform fully in both directions and
inspect the bleed screws for leaks.
2-3
Platform Overload System
How to Calibrate the Platform
Overload System
Calibration of the platform overload system is
essential to safe machine operation. Continued
use of an improperly calibrated platform overload
system could result in the system failing to sense
an overloaded platform. The stability of the
machine is compromised and it could tip over.
Note: Perform this procedure with the machine on
a firm, level surface.
1 Turn the key switch to platform control. Start
the engine and level the platform.
2 Determine the maximum platform capacity.
Refer to the machine serial plate.
3 Remove all weight, tools and accessories
from the platform.
Note: Failure to remove all weight, tools and
accessories from the platform will result in an
incorrect calibration.
4 Using a suitable lifting device, place a test
weight equal to the maximum platform
capacity at the center of the platform floor.