Terex Genie Z-40, Service And Repair Manual, Page: 16 / 287

Service and Repair Manual June 2022
Specifications
2 Z ® -62/40 Part No. 1268555GT
Perfor man ce Speci ficatio ns Performance Specifications
Drive speed, maximum
stowed position
2WD models
3.0 mph
4.8 km/h
40 ft / 9.1 sec
12.2 m / 9.1 sec
4WD models 3.2 mph
5.1 km/h
40 ft / 8.5 sec
12.2 m / 8.5 sec
TRAX models 2.3 mph
3.7 km/h
40 ft / 11.9 sec
12.2 m / 11.9 sec
Elevated 0.7 mph
1.0 km/h
40 ft / 40 sec
12.2 m / 40 sec
Gradeability See Operator's Manual
Braking distance, maximum
High range on paved surface 3 to 6 ft
0.9 to 1.8 m
Joystick function speeds, maximum from platform
controls
Jib boom up
68 to 73 seconds
Jib boom down
77 to 82 seconds
Primary boom up
60 to 65 seconds
Primary boom down 65 to 70 seconds
Primary boom extend 40 to 45 seconds
Primary boom retract
45 to 50 seconds
Secondary boom up 40 to 45 seconds
Secondary boom down 45 to 50 seconds
Turntable rotate, 360°
Stowed
120 to 125 seconds
Turntable rotate, 360°
Not stowed
240 to 245 seconds
For operational specifications, refer to the
Operator's Manual.
Hydraulic Oil Specific ations Hydraulic Oil Specifications
Hydraulic Fluid Specifications
Genie specifications require hydraulic oils which are
designed to give maximum protection to hydraulic
systems, have the ability to perform over a wide
temperature range, and the viscosity index should
exceed 140. They should provide excellent antiwear,
oxidation prevention, corrosion inhibition, seal
conditioning, and foam and aeration suppression
properties.
Cleanliness level,
minimum
ISO 15/13
Water content,
maximum
250 ppm
Recommended Hydraulic Fluid
Hydraulic oil type
Chevron Rando HD Premium
Viscosity grade 32
Viscosity index 200
Optional Hydraulic Fluids
Mineral based Shell Tellus S2 V 32
Shell Tellus S2 V 46
Shell Tellus S4 VX 32
Shell Donax TG (Dexron III)
Chevron 5606A
Biodegradable Petro Canada Environ MV 46
Fire resistant UCON Hydrolube HP-5046
Note: Genie specifications require additional
equipment and special installation instructions for
the approved optional fluids. Consult Genie
Product Support before use.
Optional fluids may not have
the same hydraulic lifespan and
may result in component
damage.
Note: Extended machine operation can cause the
hydraulic fluid temperature to increase beyond its
maximum allowable range. If the hydraulic fluid
temperature consistently exceeds 200°F / 90°C an
optional oil cooler may be required.