Terex Genie S-80, Service And Repair Manual, Page: 38 / 301

Service and Repair Manual March 2018
Platform Components
24 S®- 80 • S® -85 • S® -80X Part No. 1269074GT
2-1
Platform
How to Remove the Platform
1 Remove the cable clamp from the top of the
platform mounting weldment.
2 Remove the mounting fasteners from the
power to platform outlet box bracket. Lay the
outlet box and bracket assembly off to the
side. Do not disconnect the wiring.
3 Remove the foot switch mounting fasteners.
4 Remove the cover plate from the bottom of the
foot switch to access the foot switch wire
terminals.
5 Tag and disconnect the foot switch wiring from
the foot switch. Remove the cable from the
back of the platform.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
6 Remove the platform control box mounting
fasteners. Lower the control box and set it
aside.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
Note: If your machine is equipped with an airline to
platform option, the airline must be disconnected
from the platform before removal.
7 Support and secure the platform to an
appropriate lifting device.
8 Remove the platform mounting fasteners and
remove the platform from the machine.
Crushing hazard. The platform
could become unstable and fall
when it is removed from the
machine if not properly
supported.