Terex Genie S-60 DC, Service And Repair Manual

Page: 78 / 171

Service and Repair Manual July 2021
Control System Fault Codes
66 S ® -60 DC • S ® -60 FE Part No. 1299608GT
How to Retrieve Control System
Fault Codes from the Platform
Controls
At least one fault code is present when the alarm
at the platform controls produces one short beep
every 30 seconds. Refer to Navigation Menus,
Faults Menu .
1 Turn the key switch to platform control.
2 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
3 Do not press down the foot switch.
4 Move and hold the drive enable toggle switch
in the right direction and hold steer in the right
direction.
5 When the display leaves SYSTEM READY
mode, release the drive enable toggle switch
and steer.
Result: The display will show FAULTS.
To access active faults list:
6 Momentarily activate the drive enable toggle
switch in the right direction until ACTIVE
FAULTS is shown on the display.
7 Momentarily activate the drive enable toggle
switch in the right direction to access the
active fault codes.
8 Activate steer in the right direction to scroll
through the fault codes. Fault codes will be
listed in order 1 through 16.
To access motor controllers and battery
charger faults list:
9 Momentarily activate the drive enable toggle
switch in the right direction until
COMPONENT FAULTS is shown on the
display.
10 Momentarily activate the drive enable toggle
switch in the right direction to access the
active fault codes.
11 Activate steer in the right direction to scroll
through the fault codes. Active fault codes will
be listed in sequence.
To access fault history list:
12 Momentarily activate the drive enable toggle
switch in the right direction until ACTIVE
FAULTS is shown on the display.
13 Activate the steer rocker switch in the right
direction until FAULT HISTORY is shown on
the display.
14 Momentarily activate the drive enable toggle
switch in the right direction to access the fault
history list codes.
15 Activate the steer rocker switch in the right
direction to scroll through the fault codes.
Fault codes will be listed in order 1 through
16.
16 Refer to the Control System Fault Codes
chart to aid in troubleshooting the machine by
pinpointing the area or component affected
To clear fault history
17 Momentarily activate the drive enable toggle
switch in the right direction until ACTIVE
FAULTS is shown on the display.
18 Activate steer in the right direction until
CLEAR FAULTS HISTORY is shown on the
display.
19 Momentarily activate the drive enable toggle
switch in the right direction to enter CLEAR
FAULTS HISTORY.
Result: CLEAR FAULT HISTORY? NO will
appear on the display.
20 Momentarily activate drive enable right to
enter menu.
Result: Enable will appear at the bottom of the
display.
21 Activate steer in the right direction to change
the display from NO to YES.
22 Activate the drive enable toggle switch in the
right direction to accept the change.
Result: The alarm will sound for one second.
All fault history listings and counters will be
cleared.