Terex Genie S-60 DC, Service And Repair Manual

Page: 72 / 171

Service and Repair Manual July 2021
Axle Components
60 S ® -60 DC • S ® -60 FE Part No. 1299608GT
10-2
How to Remove the Steer
Cylinder
1 Adjust the steer tires so they are in a straight
driving position.
2 Turn the key switch to the off position.
3 Push in the red Emergency Stop button to the
off position at both the ground and platform
controls.
4 Remove the drive chassis cover at the steer
end of the machine.
5 Remove the cable clamp securing the steer
sensor cable to the chassis.
6 Tag and disconnect the steer sensor harness
from the main harness.
7 Tag, disconnect and plug the hydraulic hoses
from the steer cylinder. Cap the fittings on the
cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
8 Remove the rue ring and clevis pin from each
end of the cylinder.
9 Remove the cylinder from the machine.
Component damage hazard.
Hoses and cables can be
damaged if they are kinked or
pinched.
How to Calibrate the Steer Angle Sensor How to Calibrate the Steer Angle
Sensor
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position.
Refer to Navigation Menus,
Settings Menu
.
1 Turn the key switch to platform controls.
2 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
3 Adjust the steer wheels so they are pointing
straight ahead, in line with the non-steer
wheels. Release the foot switch.
4 Move and hold the drive enable toggle switch
in the right direction while holding steer in the
right direction.
5 When the display leaves SYSTEM READY
mode, release the drive enable toggle switch
and the steer joystick.
Result: The display will show FAULTS.
6 Momentarily activate steer in the right
direction until SETTINGS is shown on the
display.
7 Momentarily activate the steer right direction
until you see the DRIVE SETTINGS screen.
8 Momentarily activate the drive enable toggle
switch in the right direction until you see the
STEER SENSOR CAL screen.