Operator's Manual
Fifth Edition • Fifth Printing
Transport and Lifting Instructions
46 GS
™
-30 • GS
™
-32 • GS
™
-46
Part No. 114313GT
Transport and Lifting Instructions
Observe and Obey:
Genie provides this securement information as
a recommendation. Drivers are solely
responsible for making sure machines are
properly secured and the correct trailer is
selected pursuant to US Department of
Transportation regulations, other localized
regulations, and their company policy.
Genie customers needing to containerize any
lift or Genie product should source a qualified
freight forwarder with expertise in preparing,
loading and securing construction and lifting
equipment for international shipment.
Only qualified aerial lift operators should move
the machine on or off the truck.
The transport vehicle must be parked on a
level surface.
The transport vehicle must be secured to
prevent rolling while the machine is being
loaded.
Be sure the vehicle capacity, loading surfaces
and chains or straps are sufficient to withstand
the machine weight. Genie lifts are very heavy
relative to their size. See the serial label for the
machine weight.
The machine must be on a level surface or
secured before releasing the brakes.
Do not allow the rails to fall when the snap pins
are removed. Maintain a firm grasp on the rails
when the rails are lowered.
Do not drive the machine on a slope that
exceeds the uphill, downhill or side slope rating.
See Driving on a Slope in the Operating
Instructions section.
If the slope of the transport vehicle bed
exceeds the maximum slope rating, the
machine must be loaded and unloaded using a
winch as described in the brake release
operation.
Brake Release
Operation
1
Chock the wheels to prevent the machine from
rolling.
2
Be sure the winch line is properly secured to
the drive chassis tie points and the path is clear
of all obstructions.
3
Push in the black brake release knob to open
the brake valve.
4
Pump the red brake release pump knob.
After the machine is loaded:
1
Chock the wheels to prevent the machine from
rolling.
2
Pull out the red Emergency Stop button at both
the ground and platform controls to the on
position.
3
Press the drive function select button. Press
and hold the drive/steer function enable switch
on the control handle. Move the control handle
off center and immediately release it to reset
the brakes.
4
Push the red Emergency stop button at both
the ground and platform controls to the off
position.
Towing the Genie GS-1530, GS-1532, GS-1930,
GS-1932, GS-2032, GS-2632, GS-3232, GS-2046,
GS-2646 and GS-3246 is not recommended. If the
machine must be towed, do not exceed 3.2 km/h.
Summary of Contents for Genie GS-2032
Page 62: ......
