2-2
2.3 Standard specifications
Model
VKN-e VKP-e
Quality
Grinding fluid, cutting fluid, etc.
Note 1
Temperature
40°C or lower (No frozen liquid is allowed.)
Applicable
liquid
Dynamic viscosity
See “Note 2.”
Indoors, Height above sea level: 1,000 m or less, Humidity:
85%RH or less (No condensation is allowed.), Place not
exposed to direct sunlight, Place whose atmosphere contains no
corrosive gas, explosive gas or vapor
Installation location
Ambient temperature:
0 to 40°C
Ambient temperature:
–20 to 40°C
Bore [Rp]
1 1/2
2
Max. suction pipe length
Note 3
0.7 m or shorter
–
Casing, pump leg
FC150/200
Impeller CAC407
Material
Motor main shaft
S45C
Shaft sealing structure
Mechanical seal
(carbon, ceramics)
–
Type
Totally-enclosed fan-cooled indoor type
IP protection
IP54
Power
Note 4
3-phase 50/60Hz
200/200-220V
Insulation class
Class F
Number of poles
2P
Motor
Standard
IEC60034-1
Noise [dB(A)]
78
75
Coating color
Munsell N1
Note 1 Note that the product cannot be used for water or special liquids such as printing liquids or acidic
liquids.
Note 2 If you pump liquids with a dynamic viscosity beyond the limit specified in the following table, the
service life of the motor may become shorter and the motor may burn out. Be sure to use a liquid
with a dynamic viscosity below the limit specified in the following table. Note that a decrease in
liquid temperature could significantly increase its dynamic viscosity. Before pumping a liquid,
check its dynamic viscosity at the minimum liquid temperature. The characteristics of the pump
deteriorate as an increase in the dynamic viscosity of the liquid.
Maximum allowable limit of dynamic
viscosity for liquids to be pumped [mm
2
/s]
Model
Running at 50Hz
Running at 60Hz
VKN115A-e 200
75
VKP115A-e 300
150
Note 3 If the bore size is different from the standard size, the maximum suction pipe length is inversely
proportional to the square of the bore size.
Note 4 Limit the fluctuations of the power voltage within ±10% of the rated voltage, and also limit the
fluctuations of the frequency between –5% and +3% of the rated value. Avoid continuous
operation if the voltage is not within ±5% of the rated value or if the frequency is not within ±2% of
the rated value.
* This product is labeled with a self-declaration CE mark and complies with the Essential Safety
Requirements (ESRs) of the “EU (EC) Directive.” The following are the general descriptions.
*
