ENC-400-HDMI
™ H.264 Encoder
User Guide V 2.1
18
Audio Loss:
If the audio input signal is lost, you can specify here what shall be
happen in this case. Following possibilities are available:
OFF
SINE
SILENCE
If ‘OFF’ is chosen, the encoder stops the streaming when the
embedded audio input is lost. When the analogue audio input is lost,
the encoder streams only the video in this case.
If ‘SINE’ is chosen, the encoder streams the video with pure tone.
If ‘SILENCE’ is chosen, the encoder steams only the video when the
embedded audio input is lost.
Transport Stream Padding:
Specifies the padding mode. You can choose between:
ON (is recommend when a constant data rate is needed)
OFF (the transport stream has a variable data rate. All settings
in the ‘VBV size’ field of the ‘video’ webpage have no effects)
LOWDELAY (no padding, data will be streamed even if frames
are not yet fully encoded. Fastest mode, but may be
incompatible to 3
rd
party decoder hardware and software)
VBR TS Rate Limit [kbps]:
Specifies the maximum transport stream rate in kBit/s when ‘Transport
Stream Padding’ is ‘OFF’.
.!. Teracue recommend the auto mode (0)
CBR TS Rate [kbps]:
Specifies the transport stream rate in kBit/s when ‘Transport Stream
Padding’ is ‘ON’.
.!. Teracue recommend the auto mode (0)
PCR/PTS Restart:
Enables / Disables the PCR/PTS restart which occurs every 24 hours.
Thereby, the PCR/PTS overflow can be avoided, which is caused by
MPEG standard.
PCR/PTS Restart Time:
Specifies the PCR/PTS restart time. The PCR/PTS restart will be
executed every 24 hours at the specified time. The left field specifies
the hours and the right field the minutes.
Table 6: Description of the 'ENCODER/SETTINGS' webpage of the ENC-
300™
