PLDC04452
REVISION 00
December 23, 2020
TECHNICAL OFFICE
Stavale
19
Blow the inside of the motor clean with a jet of compressed air, paying particular attention to the area around
the carbon brushes and to the part of the rotor
G
with which the carbon brushes come into sliding contact.
20
Check the rotor M for wear, paying particular attention to the area of contact with the carbon brushes.
21
When repositioning the metal strap over the carbon brushes
F
, align the notch
H
in the strap with the
corresponding reference on the motor body.
22
Arrange the clamp H1 of the metal strap H as shown in the figure below when reassembling.
1
Repeat the dismantling operations in reverse.
2
To reassemble the carbon brushes, perform the dismantling operations in reverse.
3
Reposition the protection clamp, making sure it is positioned on the catch, for correct assembly see Figure 9
4
To reassemble the solution tank, perform the dismantling operations in reverse.
5
Tighten the four screw A, B to a maximum torque of 22 Nm / ~ 195 lbf in.
Reassembly
Fig. 9
Fig. 10
G
Fig. 8
H
8 of 68
