Tennant 800, Service Manual

Page: 19 / 402

GENERAL INFORMATION
1--17
800/810 MM337 (6--01)
Interval Key Description Procedure
Lubricant/
Fluid
No. of
Service
Points
100 Hours
6 Hydraulic fluid reservoir Check fluid level HYDO 1
7 Hydraulic fluid cooler Clean cooler fins 1
8 Radiator
Clean core exterior 1
Check coolant level WG 1
Clean screen -- 1
-- Tires Check pressure -- 3
13 Main brush & hopper seals Check for damage or wear -- 12
12 Engine crankcase
H
Change oil and filter element EO 1
12 Engine fan belt
H
Check tension -- 1
12 Air cond. belt (option) Check tension -- 1
-- Air cond. filter (option) Clean or replace if necessary -- 1
200 Hours
12 Engine Steam clean exterior -- 1
8 Radiator hoses and clamps Check for tightness and wear -- 2
11 Rear wheel support
bearings
Lubricate SPL 2
5 Parking brake Check adjustment -- 1
3 Side brush pivot pins Lubricate SPL 1
400 Hours
12 Fuel filter, Engine Replace -- 1
12 Water separator / fuel filter Replace -- 1
8 Cooling system Flush WG 1
4 Brake master cylinder Check fluid level BF 1
800 Hours 6 Hydraulic reservoir Replace filler cap GL y
Replace suction strainer GL 1
Change hydraulic fluid HYDO 1
9 Hydraulic fluid filter
H
Change filter element 1 9 Hydraulic fluid filter
H
Change filter element -- 1
9 Hydraulic hoses Check for wear and damage -- 49
11 Propelling motor
H
Torque shaft nut -- 1
-- Rear wheel
H
Torque wheel nuts -- 1
16 Battery
H
Clean and tighten battery cable
connections
-- 1
1600
Hours
14 Front wheel bearings Check, lubricate, and adjust SPL 2
LUBRICANT/FLUID
BF Brake fluid . . . .
EO Engine oil, 10W30 diesel rating above CD grade only . . . .
HYDO Tennant Company or approved hydraulic fluid .
SPL Special lubricant, Lubriplate EMB grease (TENNANT part no. 01433--1) . . .
WG Water and permanent-type ethylene glycol anti-freeze, --34
_
C (--30
_
F) . . .
NOTE: Also check procedures indicted (
H
) after the first 50-hours of operation.