EN
OPERATION
8
Tennant 2550 (02--01)
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE--OPERATION
1. Sweep floor and remove debris.
2. Check condition of pad.
3. Check battery charge level
(For accurate reading,
brush must be spinning).
4. Check that dust control bag is installed.
5. Make sure floor is dry.
BURNISHING WITH THE MACHINE
1. Release parking brake lever if set.
2. Turn on key, main power and pad switches.
3. Turn speed control knob to slowest speed. This
will prevent an abrupt take off.
Adjust Speed Control Knob
4. Twist control grips forward to begin burnishing.
Gradually turn speed control knob to desired
cleaning speed.
Twist Grips to Burnish
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
5. Adjust pad pressure meter within Green Zone.
Press the Pad Pressure switch to decrease or
increase pressure. For best results adjust needle
as shown.
Meter Needle
GREEN
ZONE
RED
ZONE
Pad Pressure Meter
ATTENTION: Do not operate machine in red zone,
floor damage and brush motor overload may
result.
NOTE:
If machine vibrates, realign pad.
ATTENTION: Keep machine moving at all times to
prevent floor damage.
6. To stop machine, release grips. The pad will
automatically raise to the transport position.
7. To operate machine in reverse, release grips and
pull reverse trigger (one speed).
Reverse Trigger
8. To transport machine, turn off pad switch and twist
control grips. Pad will automatically raise to the
transport position.
Turn Off Pad Switch
