13
3.2.6
DC Voltage Setting
DC voltage output is the setting of DC offset on powering on.
Steps for changing DC offset voltage to 3V are seen as follows:
1. Press Menu
→Waveform→Type→DC in turn to enter parameter setting mode.
2. Use number keyboard to input the required number of 3.
3. Select required unit V
Note: This parameter can be set by multifunctional control and direction buttons.
3.2.7
Ramp Wave Setting
Default symmetry degree of ramp wave is 100%.
Steps for setting triangular wave with 10kHz frequency, 2V amplitude, 0V DC offset and 50% duty cycle
are shown as follows:
Press Menu
→Waveform→Type→RampWave→Parameter in turn to enter parameter setting mode. Select
parameter to enter edit mode, then input required numbers and select unit. Note: When enter symmetry degree
value, there is a 50% label at the bottom of display, press corresponding softkey or use number keyboard.
Note: This parameter can be set by multifunctional control and direction buttons.
