Blizzard Enclosure User Manual
page 12
Installing the Blizzard Blimp Accessory
If you ordered a Blimp kit with your Blizzard, the installation is exactly the same, except that the fan is
remote from the enclosure and needs to be installed separately.
The Blimp kit provided with your enclosure comprises additional sound insulation inside the enclosure,
plus a remote fan kit.
1.
Attach a Hose adapter plate to the exhaust air location on the right side of the rear panel,
using the four 8-32 screws provided
2.
Thread the fan cable through the padded hose provided, using a fish tape
3.
Pass the fan cable through the hose adapter, and connect to the FAN terminals inside the
enclosure, passing the fan cable through the rubber grommet in the side of the electrical
cover.
4.
Attach one end of the hose to the hose adapter plate, using one of the clamps provided.
5.
Attach the other end to the Fan assembly in the same way, taking care not to crimp the fan
cable.
6.
Feed the hose through the wall or ceiling to a suitable location and screw in place. This will
normally be either in a large ceiling void, or in a remote location with access to outside air.
7.
DO NOT EXTEND the hose beyond its 25’/7.6m length. It has been tested at this length, and
extending it further may reduce cooling efficacy inside the enclosure.
The latch tension is
adjusted by turning the
screw – clockwise to
tension, anti-clockwise to
loosen.
Insert a padlock in
one or more
security rings for
additional security.
