16
Instructions manual |
www.grupotemper.com
KDP
Remote control
Button
Function
To adjust Lux value
By pressing corresponding button, the selected light level
threshold is set to presence detector for switching on the
connected load. Load II (CH2) is independent of Lux value.
To read-in the actual ambient light level
Actual ambient light level can be read-in as threshold for
switching the connected load, if the provided Lux values do not
match user
’
s requirement.
The steps are as below: Press
button till detector
’
s red LED
flashing to enter into learning mode, learning time is 10sec.
Then the actual ambient light level is read-in confirmed by
both load and LED turn on for 5sec to indicate
ＫＤＰ
learning
successfully and then turn off. Afterwards, it returns to Auto
mode.
Note: If the ambient light level is out of the range of 10 -
2000Lux, detector will learn for 10sec, then LED flashes quickly
for 5sec to indicate KDP learning is failed, and the alternative
of 10Lux or 2000Lux value will be stored depending on under
10Lux or above 2000Lux value.
To set delay off TIME1 (Lighting)
By pressing corresponding button, the desired switching off
delay time of load I(CH1) can be exactly set, it is confirmed by
flashing of detector
’
s LED for 2sec.
Test mode
• By pressing this button to enter into Test mode, it is
confirmed by flashing of detector
’
s LED for 2sec.
Walking through the detection coverage, both load I(CH1)
and detector
’
s LED turn on 2sec once detector is triggered
(Reaction is regardless of Lux value).
• Load II(CH2) has no reaction in test mode.
