TEMA TELECOMUNICAZIONI
IP PoE Multicast Encoder
AD615/SIP
MAS-AD615SIP-REV00EN
Page 27 of 28
10.4. Appendix 3: Cabling of a RJ45 network cable according to the standard EIA568B
Pin
Signal
Connector 1
Connector 2
1
TX+
White/
Orange
White/
Orange
2
TX-
Orange
Orange
3
RX+
White/
Green
Bianco/
Green
4
PoE-
Blue
Blue
5
PoE-
White/
Blue
White/
Blue
6
RX-
Green
Green
7
PoE+
White/
Brown
White/
Brown
8
PoE+
Brown
Brown
NB: if the cable colors are different, the right matches must be
maintained.
•
Cut the sheath (about one centimeter) to discover the wires.
•
To facilitate the process it is possible, by exploiting the elasticity of the sheath, to pull the wires some
additional millimeter. (Hold with one hand the wires and with the other pull the smoothing sheath).
•
Straighten the wires previously individually pair twisted.
•
Compose the color sequence following the pattern.
•
Level the length of the cables into place.
•
Insert the tightened wires into RJ45 connector holding them between your fingers until they are channeled
into the guides inside the connector itself.
•
Push well until the wires will touch the bottom of the connector (check in transparency that all the wires are
in place).
•
Make sure that the sheath has penetrated into the connector for at least 8 mm so that it can also be
crimped.
•
Place the connector in the crimping tool and tighten all the way. Should be audible a click caused by the
outer stop.
•
Repeat exactly all the above steps to crimp the cable on the other side.
